Delucio LLC logo
Red oak strip floor with an even satin finish running from a hallway into a dining room

Hardwood Floor Repair · Glenville · Greenwich, CT · Fairfield County

Hardwood Floor Repair in Glenville, CT

Hardwood floor repair in Glenville for old houses in the mill village, colonials and ranches from the seventies, and townhouse floors with loose boards or a stubborn squeak.

  • Free In-Home Estimate
  • Licensed and Insured
  • Locally Owned in Norwalk
  • 23+ Years of Experience

Homes in Glenville

Old Boards in Glenville's Mill-Village Houses

The houses around the falls were built for mill families, mostly Irish in the nineteenth century and Polish in the twentieth. Their floors were laid by hand and have been patched more than once since. A repair here starts with reading earlier fixes, because some of them need undoing.

  • Patches nailed over old floor grates
  • Boards split around cut nails
  • Gaps where a chimney was removed
  • Uneven thresholds between rooms
  • Painted boards in a back stair

Old repairs often used whatever wood was around: pine in an oak floor, or boards of a different width. We pull those, find matching stock, and lay it so the joints fall where the original installer would have put them. Cut nails are kept where they hold and set below the surface where they do not.

Hardwood floor repair: damaged oak boards cut out of a floor, with matching replacement boards and tools beside the opening

The repair and matching

Fixing Loose Oak Over Seventies Plywood

Many Glenville colonials from the seventies have oak strip nailed over plywood that has dried and shrunk for decades. Nails lose their grip, and boards begin to click underfoot. We locate the joists, add screws through the subfloor from the basement where there is access, and draw the oak tight.

Where the basement ceiling is finished, the screws go in from above, through the face of the board, and each head is hidden under a filler matched to the oak. A floor fixed this way stays quiet, and only someone who knows where to look will spot the repairs.

Around Glenville

Repairing Floors Around the Falls and Angelus Drive

We repair floors throughout Glenville: in the old houses on Glenville Street, near the New Mill with its battlements, on Angelus Drive and its one-family houses from the sixties, around the fire station and the civic center, and in the townhouse groups close by. Each job starts with a slow walk across the room.

  • Glenville Street
  • Near the New Mill
  • Angelus Drive
  • By the fire station
  • Townhouse groups

Before we start

Patching a Townhouse Floor Without Lifting the Room

About one Glenville home in five is a townhouse, and many have one level of oak that has taken a water leak, a cracked board under the dishwasher, or deep dents by the door. We cut out the damaged section board by board, leaving the rest of the room in place.

New boards are slid in by removing the bottom of the groove, then glued and pinned, since the tongue cannot be nailed in the usual way. The patch is sanded flush and finished to match. If the association asks for a work notice, we write it with the dates and the noise expected.

Free estimate

Free Hardwood Floor Repair Estimate in Glenville

A squeak in the hall, a cracked board, or an old patch that never looked right in your Glenville house? Ask for a free visit. We find the cause, check the earlier fixes, match the wood, and send you a written estimate for each repair.

  • Free In-Home Estimate
  • Licensed and Insured
  • Locally Owned in Norwalk
  • 23+ Years of Experience

Prefer to talk? Call (475) 284-8583

Free in-home estimate · No obligation · Licensed and insured.

Call NowFree Estimate